Nederlands  English 
Tilt switch module  Elektronica onderdelen en benodigdheden webshop voor iedereen

Winkelwagen

<< Vorige - Volgende >>


Tilt switch module


Artikelcode: ARD155



Tilt switch module




Tilt switch module. Geschikt voor Arduino maar ook voor andere microcontrollers.

Example code:

/*

  Button

 Turns on and off a light emitting diode(LED) connected to digital  

 pin 13, when pressing a pushbutton attached to pin 2. 

 
 The circuit:

 * LED attached from pin 13 to ground 

 * pushbutton attached to pin 2 from +5V

 * 10K resistor attached to pin 2 from ground

 * Note: on most Arduinos there is already an LED on the board

 attached to pin 13.

 
 created 2005

 by DojoDave

 modified 28 Oct 2010

 by Tom Igoe

 
 This example code is in the public domain.

 http://www.arduino.cc/en/Tutorial/Button

 */

 

// constants won't change. They're used here to 

// set pin numbers:

const int buttonPin = 2;     // the number of the pushbutton pin

const int ledPin =  13;      // the number of the LED pin

 

// variables will change:

int buttonState = 0;         // variable for reading the pushbutton status

 

void setup() {

  // initialize the LED pin as an output:

  pinMode(ledPin, OUTPUT);      

  // initialize the pushbutton pin as an input:

  pinMode(buttonPin, INPUT);     

}

 

void loop(){

  // read the state of the pushbutton value:

  buttonState = digitalRead(buttonPin);

 

  // check if the pushbutton is pressed.

  // if it is, the buttonState is HIGH:

  if (buttonState == HIGH) {     

    // turn LED on:    

    digitalWrite(ledPin, HIGH);  

  } 

  else {

    // turn LED off:

    digitalWrite(ledPin, LOW); 

  }

}

 




€ 2.95




Voorraad:


Aantal   



Andere klanten kochten ook