Flame detection Sensor Module

Flame detection Sensor Module
Euro 3.95 *Prijzen zijn inclusief btw
ArtikelcodeARD136
Flame detection Sensor Module. Geschikt voor gebruik met Arduino of andere microcontrollers. Deze module is gevoelig voor vlammen en uitstralingsbronnen. Het kan tevens lichtbronnen detecteren in het golflengte gebied tussen 760nm-1100 nm. De detectie afstand is maximaal 100CM. Zowel digitaal als analoog output.

Op voorraad / on stock
Flame detection Sensor Module. Geschikt voor gebruik met Arduino of andere microcontrollers. Deze module is gevoelig voor vlammen en uitstralingsbronnen. Het kan tevens lichtbronnen detecteren in het golflengte gebied tussen 760nm-1100 nm. De detectie afstand is maximaal 100CM. Zowel digitaal als analoog output.


Example code:

/*

 Button


Turns on and off a light emitting diode(LED) connected to digital  

pin 13, when pressing a pushbutton attached to pin 2.


The circuit:

* LED attached from pin 13 to ground

* pushbutton attached to pin 2 from +5V

* 10K resistor attached to pin 2 from ground

* Note: on most Arduinos there is already an LED on the board

attached to pin 13.


created 2005

by DojoDave

modified 28 Oct 2010

by Tom Igoe


This example code is in the public domain.

http://www.arduino.cc/en/Tutorial/Button

*/


// constants won't change. They're used here to

// set pin numbers:

const int buttonPin = 2;     // the number of the pushbutton pin

const int ledPin =  13;      // the number of the LED pin


// variables will change:

int buttonState = 0;         // variable for reading the pushbutton status


void setup() {

 // initialize the LED pin as an output:

 pinMode(ledPin, OUTPUT);      

 // initialize the pushbutton pin as an input:

 pinMode(buttonPin, INPUT);    

}


void loop(){

 // read the state of the pushbutton value:

 buttonState = digitalRead(buttonPin);


 // check if the pushbutton is pressed.

 // if it is, the buttonState is HIGH:

 if (buttonState == HIGH) {    

   // turn LED on:    

   digitalWrite(ledPin, HIGH);  

 }

 else {

   // turn LED off:

   digitalWrite(ledPin, LOW);

 }

}